Sharp MX-5000N

MX-5001N FAN SECTION Q – 1
MX-5001N
Service Manual
[Q] FAN SECTION
1. Disassembly and assembly
A. Fan motor
(1) Rear cooling fan motor
1) Remove the rear cabinet.
2) Open the control box.
3) Disconnect the connector and remove the screw, and remove
the duct.
4) Disconnect the connector and remove the screw, and remove
the rear cooling fan motor.
* When installing, put the fan label (A) facing outside, and be
careful of the pulling direction of the harness (B).
(2) Ozone fan motor
1) Remove the rear cabinet.
2) Open the control box.
3) Remove the filter box unit.
Parts
a Rear cooling fan motor
b Ozone fan motor
c Power cooling fan motor
d Power cooling fan motor2
e Controller cooling fan motor
f Fusing fan motor
g Process air inlet fan motor
h LSU cooling fan motor
i Cartridge cooling fan motor
b
e
f
a
c
d
g
h
i
A
B