Sharp MX-5000N

MX-5001N PWB SECTION P – 7
(6) Primary transfer PWB
1) Remove the rear cabinet.
2) Open the control box.
3) Remove the screw, and remove the flywheel.
* Installing sequence: (1)C (2) KM
(Engraved mark for each color)
* After installing, check to confirm that it is not in contact with
the harness.
4) Remove the screw and disconnect the connector, and remove
the primary transfer PWB.
(7) MC PWB
1) Remove the rear cabinet.
2) Open the control box.
3) Remove the screw, and remove the flywheel.
* Installing sequence: (1)C (2) KM
(Engraved mark for each color)
* After installing, check to confirm that it is not in contact with
the harness.
4) Disconnect the connector, remove the supporter, and remove
the primary transfer PWB unit.
5) Remove the screw and disconnect the connector, and remove
the MC PWB and the supporter.
C
KM
C
KM