Sharp MX-5000N

MX-5001N DSPF SECTION C – 10
4) Remove the screw, and remove the drive unit.
(1) DSPF paper feed motor
1) Remove the rear cabinet.
2) Disconnect the connector, and open the edge saddle. Remove
the screw, and remove the DSPF paper feed motor.
(2) DSPF paper exit motor
1) Remove the rear cabinet.
2) Disconnect the connector, and open the edge saddle. Remove
the screw, and remove the DSPF paper exit motor.
(3) DSPF lift-up motor
1) Remove the rear cabinet.
2) Disconnect the connector, and open the edge saddle. Remove
the screw, and remove the DSPF lift-up motor.
G. Drive transport unit
1) Remove the rear cabinet.
2) Remove the DSPF No.1 resist roller clutch.
3) Remove the DSPF transport roller clutch.
4) Remove the DSPF cooling fan motor.
5) Loosen the screw, and loosen the belt tension. Tighten the
screw.
6) Remove the screw, and remove the drive transport unit.
Parts
a DSPF transport motor
a