MX-5001N SIMULATION 6 – 7
62 1 Used to execute the hard disk format (except operation manual area).
2 Used to check read/write of the hard disk (partial).
3 Used to check read/write of the hard disk (all areas).
6 Used to perform the self diagnostics of the hard disk.
7 Used to print the hard disk self diagnostics error log.
8 Used to format the hard disk. (Excluding the system area and the operation manual area)
10 Used to delete the job log data.
11 Used to delete the document filing data.
12 Used to set Enable/Disable of auto format in a hard disk trouble.
13 Used to format the hard disk. (only the operation manual area)
63 1 Used to display the shading correction result. Scanner
2 Used to perform shading.
3 Used to perform scanner (CCD) color balance and gamma auto adjustment. Scanner
4 Used to display the SIT chart patch density.
5 Used to perform the scanner (CCD) color balance and gamma default setting.
6 Used to display the scan level and the density level of the copy color balance adjustment patch.
7 Used to register the service target of the copy mode auto color balance adjustment.
8 Used to set the default of the service target of the copy mode auto color balance adjustment.
11 Used to set the target color balance of the copy mode auto color balance adjustment.
64 1 Test print. (Self print) (Color mode)
2 Test print. (Self print) (Monochrome mode)
4 Printer test print. (Self print) (256 gradations)
5 Printer test print. (Self print) (PCL)
6 Printer test print. (Self print) (PS)
7 Used to print the adjustment pattern of the test print .(Self print).
(The adjustment pattern of SIM46-21 is printed.)
65 1 Used to adjust the touch panel (LCD display section) detection coordinates. Operation panel section
2 Used to display the touch panel (LCD display section) detection coordinates.
5 Used to check the operation panel key input.
67 17 Printer reset Printer
24 Printer color balance adjustment (Auto adjustment) Printer
25 Printer color balance adjustment (Manual adjustment) Printer
26 Used to set the target color balance of the printer mode auto color balance adjustment. Printer
27 Used to set the service target of the printer mode auto color balance adjustment. Printer
28 Used to set the default of the service target of the printer mode auto color balance adjustment. Printer
31 Used to clear the printer calibration value. Printer
33 Used to change the gamma of the printer screen. (for PCL/PS) Printer
34 Used to set the density correction in the printer high density section. (Support for the high density section
tone gap)
Printer
36 Used to adjust the density in the low density section. Printer
52 Used to set the default of the gamma of the printer screen. (for PCL/PS) Printer
54 Printer color balance adjustment (Automatic adjustment for each dither) Printer
70 MFP PWB SRAM data clear MFP PWB
Main Sub Functions Section
To Next Page
Loading...
