MX-5001N SIMULATION 6 – 9
[DSPF]
2-2
Purpose
Operation test/check
Function (Purpose)
Used to check the operations of the sen-
sors and the detectors in the document
feed unit section and the control circuits.
Section
RSPF/DSPF
Operation/Procedure
The operating conditions of the sensors and detectors are dis-
played.
The code names of the sensors and the detectors which are active
are highlighted.
[RSPF]
[DSPF]
NOTE: SWD_LEN and SWD_AD are not ON/OFF display.
2-3
Purpose
Operation test/check
Function (Purpose)
Used to check the operations of the loads
in the auto document feed unit and the con-
trol circuit.
Section
RSPF/DSPF
Operation/Procedure
1) Select a target item of the operation check with the touch panel
key.
2) Press [EXECUTE] key.
The selected load performs the operation.
When [EXECUTE] key is pressed, the operation is terminated.
[RSPF]
[DSPF]
Item/Display Operation mode Default value
(SINGLE) 300DPI 300DPI
(346.0mm/s)
300DPI
(346.0mm/s)
400DPI 400DPI
(259.5mm/s)
600DPI 600DPI
(173.0 mm/s)
(DOUBLE) 300DPI 300DPI
(346.0mm/s)
300DPI
(346.0mm/s)
400DPI 400DPI
(259.5mm/s)
600DPI 600DPI
(173.0 mm/s)
SSET RSPF installation detection
SOCD RSPF open/close detector
SCOV RSPF cover open/close detector
SPED RSPF document empty detector
SPPD1 RSPF document pass detector 1
(Paper enter detection)
SPPD2 RSPF document pass detector 2
(Resist roller front document transport detection)
SPPD3 RSPF document pass detector 3 (Document scanning front
document transport detection)
SPPD4 RSPF document pass detector 4
(Reverse gate front document transport detection)
SPPD5 RSPF document pass detector 5
(Document reverse rear document transport detection)
SPLS1 RSPF document length detector 1 (Short)
SPLS2 RSPF document length detector 2 (Long)
STMPU SPF stamp unit installation detector
SWD_LEN RSPF guide plate position
SWD_AD RSPF document width sensor (volume) output level
SSET DSPF installation detection
SOCD DSPF open/close detector
SCOV DSPF cover open/close detector
SLCOV DSPF lower door open/close detector
SPED1 DSPF document empty detector 1
SPED2 DSPF document empty detector 2
SPPD1 DSPF document pass detection 1 (Paper enter detection)
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
63)$*,1*
300DPI '3,'3,
63)6&$1 ˖
(;(&87(
'28%/(SINGLE
SPPD2 DSPF document pass detector 2
(Resist roller front document transport detection)
SPPD3 DSPF document pass detector 3
(Document scanning front document transport detection)
SPPD4 DSPF document pass detector 4
(Reverse gate front document transport detection)
SPPD5 DSPF document pass detector 5
(Document reverse rear document transport detection)
SPOD DSPF paper exit detector
SPRDMD DSPF random feed paper size detection
SPLS1 DSPF document length detector 1 (Short)
SPLS2 DSPF document length detector (Long)
STLD DSPF document tray lower limit detector
STUD DSPF document tray upper limit detector
STMPU DSPF stamp unit installation detector
SPFM RSPF transport motor
SPRM_F RSPF paper feed reverse motor (normal rotation)
SPRM_R RSPF paper feed reverse motor (reverse rotation)
SPFC RSPF paper feed clutch
SRRC SPF resist roller clutch
SGS RSPF document exit gate solenoid
STMPS Finish stamp solenoid
SPUM DSPF paper feed motor
SPFM DSPF transport motor
SPOM DSPF paper exit motor
SLUM DSPF lift-up motor
SPFFAN DSPF fan motor
SPFC DSPF paper feed clutch
SRRC DSPF resist roller clutch
SRRBC DSPF resist roller break clutch
STRRC DSPF No. 1 resist roller clutch
STRRBC DSPF No. 1 resist roller break clutch
STRC DSPF transport clutch
STMPS Stamp solenoid
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
63)6(1625&+(&. ǂǂǂǂǂǂǂǂǂǂǂ6:'B/(16 ('B$'
66(7 62&' 6&29 63('
633' 633' 633' 633'
633' 63/6 63/6 67038
To Next Page
Loading...
