Sharp MX-5000N - Page 272

MX-5001N SIMULATION 6 – 125
62-12
Purpose
Setting
Function (Purpose)
Used to set Enable/Disable of auto format
in a hard disk trouble.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value is saved.
When it is set to Enable, if a read error of HDD occurs in the system
data storage area (FAX/device cloning data, etc.), only the system
data storage area is cleared.
62-13
Purpose
Data clear
Function (Purpose)
Used to format the hard disk. (only the
operation manual area)
Section
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
The operation manual data are deleted.
When the operation is completed, [EXECUTE] key returns to the
normal display.
63
63-1
Purpose
Adjustment/Setting/Operation data check
Function (Purpose)
Used to display the shading correction
result.
Section
Scanner
Operation/Procedure
1) Select a target color to display with [R] [G] [B] on the touch
panel.
[DSPF]
A 0 Enable
1 Disable (Default)
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
'2&80(17),/,1*'$7$&/($5


$5(<28685("
<(6 12 (;(&87(
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
$872)250$76(77,1*+''7528%/(



$˖
˷˹
˖<(612
$˖
2.
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
+'')250$70$18$/:$7(50$5.$5($21/<


$5(<28685("
<(6 12 (;(&87(
Item/Display Content NOTE
GAIN ODD Gain adjustment value
(odd number)
GAIN EVEN Gain adjustment value
(Even number)
OFFSET
ODD
Offset value
(odd number)
OFFSET
EVEN
Offset value
(even number)
SMP AVE
ODD
Reference plate
sampling average
value (ODD)
SMP AVE
EVEN
Reference plate
sampling average
value (EVEN)
TARGET
VALUE
Target value
BLACK
LEVEL
Black output level
ERROR
CODE
Error code
(0, 1 - 14)
(for debug)
0 No error
1 STAGE1: Loop number
over
2 STAGE2: The target value
is under the specified
value.
3 STAGE3: The gain set
value is negative.
4 END is not asserted.
(Gain adjustment)
5(reserve)
6 STAGE2: Underflow
7 Black shading error
8 Other error
9 END is not asserted.
(White shading)
10 END is not asserted.
(Black shading)
11 END is not asserted.
(Light quantity correction)
12 END is not asserted.
(Scan)
13 Register check error.
(When booting/Gain)
14 Register check error.
(Before light quantity
correction)
DSPF FACE
WHITE
LEVEL 1ST
First scan DSPF white
reference level
DSPF FACE
WHITE
LEVEL 2ND
Second scan DSPF
front surface white
reference level