Sharp MX-5000N

MX-5001N SIMULATION 6 – 134
64-7
Purpose
Operation test/check
Function (Purpose)
Used to print the adjustment pattern of the
test print .(Self print). (The adjustment pat-
tern of SIM46-21 is printed.)
Section
Operation/Procedure
1) Set the print conditions.
Select an item to be print condition with [↑] [↓] keys.
Set the print conditions with 10 key.
2) Press [EXECUTE] key.
The adjustment pattern of SIM46-21 is printed.
65
65-1
Purpose
Adjustment
Function (Purpose)
Used to adjust the touch panel (LCD dis-
play section) detection coordinates.
Section
Operation panel section
Operation/Procedure
Touch the center of the cross mark at the four corners of the
screen.
When the adjustment is completed normally, the screen shifts to
the simulation sub number entry menu.
In case of an error, the screen returns to the adjustment menu.
65-2
Purpose
Operation check/test
Function (Purpose)
Used to display the touch panel (LCD dis-
play section) detection coordinates.
Section
Operation/Procedure
Touch the touch panel.
The coordinates X (horizontal direction) and Y (vertical direction) of
the touched position is displayed in real time.
65-5
Purpose
Operation check/test
Function (Purpose)
Used to check the operation panel key
input.
Section
Operation/Procedure
Press the keys sequentially according to the guidance displayed on
the screen.
If the key entry is effective, the guidance for pressing the next key
is displayed. When all the key entries are completed, "COMPLETE"
is displayed.
<Check target key>
Item/Display Content
Setting
range
Default
value
Writing
A COPIES Number of print 1 - 999 1 No
B PROC
ADJ
YES 0 The half tone
process control
correction
value is
reflected.
0 - 1 1 Yes
NO 1 The half tone
process control
correction
value is not
reflected.
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
(1*,1(&2/25%$/$1&(3$7&+35,1702'(



$˖
˷˹
˖&23,(6
$˖
˖352&$'-12
%˖
2.
(;(&87(
8.5 Inch LCD model 8.1 Inch LCD model
JOB STATUS DOCUMENT FILING
SYSTEM SETTINGS IMAGE SEND
HOME COPY
1JOB STATUS
2 FUNCTION
3 SYSTEM SETTINGS
41
52
63
74
85
96
AUDIT CLEAR 7
08
PROGRAM 9
CLEAR AUDIT CLEAR
STOP 0
CLEAR ALL/RESET PROGRAM
START (COLOR) CLEAR
START (MONO) STOP
CLEAR ALL/RESET
START (COLOR)
START (MONO)
;<





    







