Sharp MX-5000N

MX-5001N MAINTENANCE 8 – 22
22) Remove the secondary belt transfer frame.
23) Remove parts as outlined below.
Maintenance: Clean at every 300K.
24) Remove the secondary transfer belt.
Maintenance: Replace at every 300K.
25) Clean the secondary transfer belt drive roller and the second-
ary transfer idle shaft.
Maintenance: Clean at every 300K.
26) Remove the bearing on the front side, and remove the second-
ary transfer roller.
Maintenance: Replace at every 300K.
27) Push up the shutter, and clean the pro-reg sensor.
Maintenance: Clean at every 150K.
1
2
1
2