Sharp MX-5000N

MX-5001N DEVELOPING SECTION K – 3
3) Check that the lock is released as shown in (A).
Loosen the blue screw, and open the drum positioning unit.
* When the lock is not released, use a screwdriver to turn the
screw (B) counterclockwise so that it is fit as (A).
4) Open the DV lock lever, and release the fixing screw.
(1position for each color)
5) Pinch the knob and remove the development unit.
(1) Density sensor
1) Remove the developing unit.
2) Remove the screw, and remove the DV guide.
Remove the screw, and disconnect the connector.
Remove the density sensor.
A
B
1
2