MX-5001N ADJUSTMENTS 5 – 11
5-A Color image density sensor (image
registration sensor F) calibration
1) Open the front cabinet of the main unit, and remove the waste
toner box.
2) Remove the primary transfer unit fixing screw.
3) Turn to the transfer belt tension release cam and release the
primary transfer belt tension.
CAUTION: When the transfer belt tension of the primary transfer
unit is released manually, turn on the power again after
completion of the work. This procedure initializes the
transfer roller to return it to the home position.
4) Open the right cover unit (secondary transfer unit section).
5) Open the process front cover, and pull out the primary transfer
belt unit.
6) Install the color image density sensor (image registration sen-
sor F) calibration jig (UKOG-0318FCZZ) to the sensor housing
section.
Engage the pawls (A) in the sensor housing groove, and slide
it to the rear frame side.
NOTE: Be careful not to damage the PTC terminal.
7) Turn on the power and enter SIM44-13 mode.
8) Close the right cover unit (secondary transfer unit section).
9) Install the waste toner bottle to the main unit.
10) Close the front cabinet.
UNLOCK
A
A
EXECUTE
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
3$7&+6($/$'-8670(17
(;(&87(
3&6B&/&$5%287
3&6B&//('$'-
ǂǂǂ6,08/$7,21
ǂǂ12
&/26(
7(67
3$7&+6($/$'-8670(17
(;(&87(
3&6B&/&$5%287
3&6B&//('$'-
To Next Page
Loading...
