MX-5001N ADJUSTMENTS 5 – 18
2) Select set item J with the scroll key and enter the value corre-
sponding to the paper feed tray to be adjusted.
3) Set A4 (11" x 8.5") paper in the paper feed tray selected in pro-
cedure 2).
4) Press [EXECUTE] key.
The adjustment pattern is printed.
5) Check that the adjustment pattern image is printed in the cor-
rect position.
Measure the dimension of the void area in the front and the
rear frame direction of the adjustment pattern, and check that
all the following conditions are satisfied.
RV: REAR VOID AREA
FV: FRONT VOID AREA
RV + FV ≤ 4.0mm
RV = 2.0 ± 2.0mm
FV = 2.0 ± 2.0mm
If the above requirement is not met, do the following steps.
6) Select the paper feed mode adjustment item (B - H) to be
adjusted with the scroll key.
7) Change the adjustment value.
Enter the adjustment value and press the [OK] key or the
[EXECUTE] key.
When [EXECUTE] key is pressed, the adjustment pattern is
printed.
When the adjustment value is increased, the adjustment pat-
tern is shifted to the front frame side. When it is decreased, the
adjustment pattern is shifted to the rear frame side.
When the set value is changed by 1, the shift distance is
changed by about 0.1mm.
Repeat procedures 3) - 7) until the conditions of procedure 5)
are satisfied.
In case a satisfactory result cannot be obtained by repeating
the above procedures, perform the following procedure.
Display/Item Content
Setting
range
De-
fault
A BK-MAG Main scan print
magnification ratio BK
60 - 140 100
B MAIN-MFT Print off center adjustment
value (Manual paper feed)
1 - 99 50
C MAIN-CS1 Print off center adjustment
value
(Tray 1)
1 - 99 50
D MAIN-CS2 Print off center adjustment
value
(Tray 2)
1 - 99 50
E MAIN-CS3 Print off center adjustment
value
(Tray 3)
1 - 99 50
F MAIN-CS4 Print off center adjustment
value
(Tray 4)
1 - 99 50
G MAIN-LCC Print off center adjustment
value
(LCC)
1 - 99 50
H MAIN-ADU Print off center adjustment
value (ADU)
NOTE: Before execution of
this adjustment,
check to insure that
the adjustment
items A - G have
been properly
adjusted. If not, this
adjustment cannot
be made properly.
1 - 99 50
I SUB-MFT Registration
motor ON
Timing
adjustment
Manual
paper feed
1 - 99 50
J SUB-CS12 Standard
tray
1 - 99 50
K SUB-CS34 DESK 1 - 99 50
L SUB-LCC LCC 1 - 99 50
M SUB-ADU ADU 1 - 99 50
N MULTI COUNT Number of print 1 - 999 1
O PAPER MFT Tray
selection
Manual paper
feed
1 - 6 1 2
(CS1)
CS1 Tray 1 2
CS2 Tray 2 3
CS3 Tray 3 4
CS4 Tray 4 5
LCC LCC 6
P DUPLEX YES Duplex
print
selection
Yes 0 - 1 0 1
(NO)
NO No 1
RV
2.0mm
2.0mm
FV
2.0mm
2.0mm
To Next Page
Loading...
