Sharp MX-7090N

7-5
SYSTEM SETTINGS►SETTING MODE LIST
SETTING MODE LIST
The following is a list of setting mode items, factory default settings and restrictions for each item.
Status
U: General user; A: System administrator/Administrator
* Some settings can only be configured by the administrator.
Address Book
U: General user; A: System administrator/Administrator
*1 This setting is configured in setting mode on the web page.
*2 Set the Category Setting in System Settings→Image Send Settings→Common Settings→Category Setting of the machine's
setting mode.
SETTING MODE LIST
• Depending on the machine specifications and peripheral devices installed, it may not be possible to use some settings.
• Some setting items can only be configured on the Web page.
Setup Items Factory default setting U A
■ Status (page 7-42)
● Machine Identification (page 7-42) – Yes
*
Yes
● Total Count (page 7-43) – Yes Yes
● Device Status (page 7-43) – Yes Yes
● Network Status (page 7-44) – Yes Yes
● Firmware Version (page 7-45) – No Yes
● Power Reset (page 7-45) – No Yes
● Data List (page 7-45) – Yes Yes
 List for User – Yes Yes
 List for Administrator – No Yes
Setup Items Factory default setting U A
■ Address Book (page 7-47)*
1
● Address Book (page 7-47) – Yes Yes
● Category Setting (page 7-49)*
2
– Yes Yes