Sharp MX-7090N - Image Send Settings

7-14
SYSTEM SETTINGS►SETTING MODE LIST
Image Send Settings
Common Settings
U: General user; A: System administrator/Administrator
Setup Items Factory default setting U A
● Common Settings (page 7-103)
 Condition Settings No Yes
 Hold settings for a while after scanning has been
completed
Disabled
No Yes
 Job Auto Start Time During Scanning 60sec.
 Default Display Setting E-mail No Yes
 Address Book Default Selection No Yes
• Higher priority is given to the display of address
book.
Disabled
No Yes
• Apply Addresses of Sending Modes Only Enabled No Yes
 Category Displayed as Default None No Yes
 Display all address type regardless of the mode being
displayed currently.
Disabled
No Yes
 Enlarge Address Book Enabled No Yes
 Image Orientation Portrait No Yes
 Default Exposure Settings Auto No Yes
 Default Original Image Type Text No Yes
 Be sure to press Next Address Key ([+]) before
selecting the next address.
Disabled
No Yes
 Scan Complete Sound Setting Middle No Yes
 Disable Switching of Display Order Disabled No Yes
 Default Verification Stamp* No Yes
• E-mail/Scan/Data Entry Disabled No Yes
 Erase Width Adjustment No Yes
• Edge Clearance Width 1/2" (10mm) No Yes
• Center Clearance Width 1/2" (10mm) No Yes
 Enable/Disable Settings No Yes
 Settings to Disable Registration No Yes
• Disable Registering Destination from Operation
Panel
All Invalid
No Yes
• Disable Registering Destination on Web Page Disabled No Yes
• Disable Registration/Delection of All Program Items Disabled No Yes
• Disable Destination Registration Using Global
Address Search
Disabled
No Yes
• Disabling of Forwarding via Network Disabled No Yes
 Settings to Disable Transmission No Yes
• Disable [Resend] on Image Send Mode Disabled No Yes
• Disable Selection from Address Book All Invalid No Yes