Sharp MX-7090N - Page 618

7-21
SYSTEM SETTINGS►SETTING MODE LIST
• Display Paper Tray Settings when bypass tray
detects paper.
Enabled Yes Yes
• Tray 1 Plain Paper 1, 8-1/2" x 11" (A4) Yes Yes
• Tray 2 Plain Paper 1, 8-1/2" x 11" (A4) Yes Yes
• Tray 3 Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
• Tray 4 Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
•Tray 5*
1, 2, 3
Plain Paper 1, 8-1/2" x 11" (A4)*
1
Plain Paper 1, 11" x 17" (A3)*
2
Plain Paper 1, Auto-Inch
(Auto-AB)*
3
Yes Yes
•Tray 6*
3
Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
• Bypass Tray Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
• Inserter (Upper) Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
• Inserter (Lower) Plain Paper 1, Auto-Inch (Auto-AB) Yes Yes
 Custom Size Registration (Bypass) Custom 1 to 7
Size Input-Inch
X=17" (420mm) Y=11" (297mm)
Yes Yes
 Paper Settings – Yes Yes
 Paper Type Registration – Yes Yes
 Operation Settings No Yes
 Condition Settings No Yes
• Enlarge Display Mode Disabled No Yes
• Message Time Setting 6 sec. No Yes
• Language Setting American English No Yes
• Default Display Setting Home Screen No Yes
• Display Favorite Menus as Default Disabled No Yes
• Display Action Panel as default. Enabled No Yes
• Icon is displayed when network cable is not
connected.
Enabled
No Yes
• Display Confirmation Dialog when job is canceled. Disabled No Yes
• Switch the Number of Sets to be Displayed for Job
Management
Progress
No Yes
• Display the estimated job start time Enabled No Yes
• Alignment Order of 10-Key Ascending order from upper left No Yes
• Setting Display from Main Unit No Yes
- Display Current Path Enabled No Yes
- Enable link of current path Enabled No Yes
• MFP Display Pattern Setting Pattern 1 No Yes
• Key Operation Setting No Yes
Setup Items Factory default setting U A