Sharp MX-7090N - Page 704

7-107
SYSTEM SETTINGS►SYSTEM SETTINGS
Item Description
Name Enter a name for the Paper Settings (maximum of 50 half or full width characters).
Search Number Set a search number.
[Default Settings] tab
Paper Weight Setting Set the paper weight to be used.
Unit Set the units used for the Paper Weight.
Paper Type
Set the paper type.
Select the paper type based on the surface finish of the paper or select the envelope.
The following types can be selected.
• Uncoated Paper
• Coated Paper (Gloss)
• Coated Paper (Matt)
• Embossed
• Envelope
Paper Information Set when Color paper, Tab Paper, or Pre-Punched paper is used.
Paper Property
Set the properties of the paper to be used.
For the properties, refer to the settings in "Paper Type Registration".
[Detail] tab
Fusing Temperature Settings Set the appropriate fusing unit temperature for the paper to be used.
Fuser Pressure Setting
Adjust the pressure on the paper.
Some types of paper such as thick paper may not bend easily, and this may cause
transfer deviations.
You can use this setting to adjust the pressure on the paper and reduce transfer
deviations.
Double Feed Detection Setting
Specify whether double feeds are detected. This function cannot be used when paper
heavier than 68 lbs. (256 g/m
2
) is used.
Primary Transfer Current Value
Setting
Set the current of the primary transfer unit that is used to transfer toner to the transfer belt.
By adjusting the current of the primary transfer unit, transfer problems such as insufficient
transfer to the transfer belt can be improved.
Select settings for both black & white and 4 color (black, cyan, magenta, yellow).
Secondary Transfer Current Value
Setting
Set the current of the secondary transfer unit that is used to transfer toner from the
transfer belt to the paper. By adjusting the current of the secondary transfer unit, transfer
problems such as insufficient transfer to the paper can be improved.
When Uncoated Paper is selected for [Paper Type]
Set for the Side 1 and Side 2 for both black & white and color.
When other than Uncoated Paper is selected for [Paper Type]
Select settings for both black & white and color.
PTC Current Value Setting
Set the PTC discharge current. The PTC discharge current can be adjusted to obtain
transferability suitable for the paper being used.
When Embossed is selected for the [Paper Type]
Set for both black & white and color.
When other than Embossed is selected for [Paper Type]
Set for black & white and color at the same time.
Transfer Condition Adjustment
Setting
Set enable/disable of transfer environment correction of Primary Transfer Current Value,
Secondary Transfer Current Value and PTC Current Value.
Motor Speed Setting You can adjust the motor speed and the speed change timing.
Registration Adjustment This performs registration adjustment.