Sharp MX-7090N - Page 707

7-110
SYSTEM SETTINGS►SYSTEM SETTINGS
(4) Tap [OK].
(5) Return to step 2 and check the result of adjustment.
If the size has deviated as a result of adjustment, repeat adjustment until the deviation is eliminated.
• The measurement line content of the measurement pattern varies depending on the paper size. Measure from the
measurement line closest to the edge of the paper.
• It may not be possible to guarantee the operation adjustment range in the Y direction of (± 3 mm) depending on the
machine settings or paper size.
• When the vertical or horizontal width is 100 mm or less, measure from the assistant line.
• If you need to use this setting together with the Side1/2, XY Ratio Settings, specify the Side1/2, XY Ratio Settings first.
• Changes in the environment of the machine, such as humidity and temperature, may cause a deviation of about 1 mm in
the Side1/2, XY Print Position.
X +5 -5 mm
X +5 -5 mm
X +5 -5 mm
X +5 -5 mm
X +5 -5 mm
X +5 -5 mm
Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm Y +6 -6 mm
X1 X1 X2 X2
Front
(Side1)
Y2
+1 -1
Y2 Y1 Y1
/10 mm : %(X) /5’’ : %(X)
-1+1
/5’’ :
100%
/100mm :
100%
X +5 -5 mm
X +5 -5 mm
Y +5 -5 mm
Folding Line
YY
X
X
Folding Line
Read the scale
(Ex.)X=-2
Read the scale
(Ex.)Y=+1m
Fold line is at+side: Input plus value
Fold line is at-side: Input minus value
Fold line is at+side: Input plus value
Fold line is at-side: Input minus value
Folding Line
Folding Line