134
SCANNER FUNCTIONS
STORING AND EDITING/DELETING A PROGRAM
This function lets you store a transmission address and scanning settings. The address and settings can be called
up when you scan a document, saving you the trouble of selecting the address and settings. Up to two programs can
be stored for scanning.
• Address Setting • Original Size • Resolution • Format • Exposure • Original scanning mode can be stored in a
program.
1
Press the [SPECIAL FUNCTION] key and select "Register Program" with the [ ] or [ ]
key, and press the [OK] key.
2
Select "Enter", "Change", "Delete", and press the [OK] key.
● Register program
1
Select "No Store", and press the [OK] key.
2
Select the program you want to store with the [ ] or [ ] key, and press the [OK] key.
Setting each screen will be displayed.
3
Press the [OK] key to perform the required settings.
Return to step 2.
4
Press the [START] key.
Programs are stored.
● Change program
Select the program you want to change, and press the [OK] key.
Change the settings same operation as for registration.
● Delete program
1
Select the program you want to delete, and press the [OK] key.
2
Select "Delete", and press the [OK] key.
USING STORED SETTINGS (PROGRAM)
Press the [Program 1] or [Program 2] key. See "BASIC TRANSMISSION PROCEDURE" (p.126).
To Next Page
Loading...
Need help?
General
