INSTALLING THE MEMORY
BACKUP BATTERY
2
3
1
Open the lithium battery compartment cover on
the battery mounting panel: using a pointed ob-
ject such as the point of a pen, push the cover
release
“@”
down and to the left, and then pull
outward.
2
Insert the lithium battery, with the + side facing
outward.
3
Close the cover: press the cover in until it clicks
into place.
REPLACE BATTERY WITH SHARP TYPE CR2025
(PART NO. UBATL0006TAZZ) OR SONY
ENER-
GYTEC TYPE CR2025 ONLY. USE OF A DIFFER-
ENT BATTERY MAY PRESENT A RISK OF FIRE
OR EXPLOSION.
B
KEEP THIS BATTERY AWAY FROM
CHILDREN. IF SWALLOWED, CONSULT A PHY-
SICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
B
BATTERY MAY EXPLODE IF MIS-
TREATED OR INSTALLED WITH POLARITY RE-
VERSED. DO NOT RECHARGE, DISASSEMBLE
OR DISPOSE OF IN FIRE.
Cautions:
l Be sure that the + and
-
poles are correctly oriented
when the battery is installed.
l Do not short-circuit, recharge, disassemble or heat the
battery.
l Should the battery leak, wipe the battery compartment
and its cover clean, and then insert a new battery.
Notes:
l The lithium battery is used to back up the calendar and
other memory functions.
. The battery will last one year of normal usage.
l Replace the battery with a new CR2025 cell when the
VIEWCAM’s
time indicator starts to fall behind the correct
time.
INSTALLING THE BATTERY IN
THE REMOTE CONTROL
To open the battery compartment, press the tab
on the left side toward the centre, and slide the
tray out.
Install the supplied CR2025 lithium battery with
its + side matching the @ marked side of the
battery holder.
Replace the lid by sliding it in the direction of the
arrow. Make sure that the @ side faces the
back of the remote control.
10
To Next Page
Loading...
Need help?
General
