2
Detaching the battery pack
1
2
_
ATTACHING AND DETACHING
THE BATTERY PACK
Attaching the Battery Rack
1
Insert the top of the battery pack (the end with
the charge marker and the
“
I
”
mark) into the
upper part of the battery compartment.
2
Press the lower part of the battery pack inward
until it clicks into place.
Detaching the Battery Pack
1
Slide the BATTERY EJECT release toward the
monitor side of the
VIEWCAM.
2
Remove the battery pack.
Caution:
l
When you slide the BATTERY EJECT release, be sure to
hold the battery pack lightly with your fingers so it does
not fall.
Battery pack handling
l
Make sure that the battery packs you take with you
will provide two to three times the time you esti-
mate will be required for the planned recording.
l Recording time is reduced in cold weather.
@The
battery is drained in Recording Standby mode.
Turn off the power if you will not be recording again
quite soon.
Cautions:
l If you remove the battery pack during recording or play-
back, the tape will remain wound around the video head
drum and may be damaged. BEFORE REMOVING THE
BATTERY PACK,
ALWAYS
STOP THE TAPE AND TURN
THE POWER OFF. Should the power source (battery or
adaptor) become disconnected during operation, recon-
nect it again immediately.
l Remove the battery pack from the
VIEWCAM
or discon-
nect the
VIEWCAM
from the AC adaptor if the
VIEWCAM
will not be used for a long time.
13
To Next Page
