control
29
USING THE INFRARED
REMOTE CONTROL
Use the
remote control to opera e
the
VIEWCAM
from a distance, such as when
$
ou want to record
yourself in a scene, or when the
VIEWCAM
is con-
nected to a TV for use as a VCR.
1
2
3
4
Set the Operate switch to CAMERA or VCR.
When CAMERA is selected
Press the MENU button to display MENU 2.
If MENU 1 is displayed, press the PAGE button
(@I)
to get MENU 2 on the monitor screen.
When VCR is selected
Press the MENU button to display the menu.
Make sure that the “REMOTE” menu item is set
to “ON”.
In Camera mode
In VCR mode
MENU
1
UBNU
*SELF
RBC
AUTO CORRECT
l
BDIT
OFF
l
SCRBBN'
NORMAL
,RBWOTB
*zoon
S
PEED
ERMAL
,RBMOTB
ON
-
I
A
ISBT
I
IPAGB
rir!SBTI
I
Press
the
MENU button to turn
off the menu.
Aim the remote control at the photoreceptor of
the
VIEWCAM,
and press control buttons to
operate the
VIEWCAM.
Notes:
. Be careful not to allow direct sunlight or bright light from
interior
rllumination
to fall onto the
VIEWCAM’s
photore-
ceptor, as this may prevent the remote control from
operating properly.
l Be sure that there are no obstacles between the remote
control and the
VIEWCAM’s
photoreceptor.
l When the “REMOTE” item setting is changed in either
Camera or VCR mode, the setting for the other mode is
automatically set to the same.
l The lithium battery normally lasts about 6 months. It can
be shorter under some operating conditions. When the
lithium battery is dead and the remote control does not
operate, replace the battery with a new one by following
the instructions on page 10.
USING THE STAND
Pull out the stand and lock it into position when you
put the
VIEWCAM
on a table or other flat surface. To
stabilize the
VIEWCAM,
make sure that the
VIEW-
CAM’s camera part stands vertically as shown.
Cautions:
l Protect the stand from strong forces. Otherwise it may
break.
l Press the stand in the direction of the arrow to fold it in,
as shown.
To Next Page
Loading...
Need help?
General
