5.
Paper holding
plate
Spool
Remove the paper holding plate from the spool.
Insert the end of the paper into the slit in the spool.
(Press
F
to feed more paper if required.)
Wind the paper two or three turns around the spool
shaft.
Mount the paper holding plate onto the take-up
spool.
Set the spool on the bearing, and press
F
to take
up excess slack in the paper.
6. Replace the printer cover.
Pass the paper end through the openings of the printer cover.
Be very careful not to cut yourself on the manual cutter.
NOTE
YourregistercanbealsousedasReceiptprinting.
WhenusingasReceiptprinting,refertothe“Printing
FormatProgramming”sectiononpage24.
In this section, how to make basic programming which you must program before starting sales
operation and basic sales operation are explained.
Dept.: Department; a category for merchandise classifications. Every sales item should belongs
to a department.
PLU: Price Look Up; a category for merchandise classifications. PLUs are used to call up
preset prices by a code entry (1-80).
VAT: Value Added Tax
X report: Report to read sales data
Z report: Report to read and reset sales data
Receipt ON/OFF function: To print or not to print receipts or journals in the REG mode.
NOTE
•Ifyourdomesticcurrencydecimalpositionisotherthan2,youmustchangethesetting.
Forsetting,pleasereferto“MiscellaneousProgramming”sectiononpage25.
•Youcancontinueprogramming(step1through3below)withoutprintingthe
programmingreportbynotpressing
u
ateachprogramstep.However,tofinish
programming,youmustpress
u
.
Whenyoupress
u
attheendofprogramming,theprogrammingreportwillbeprinted.
Onthereportyoucancheckthesettingsyoudid.Makesurethatyourprogrammingis
correctlydone.
Forreadingthereport,pleasereferto“CheckingtheProgrammedMachineSettings”
sectiononpage27.
To Next Page
Loading...
