Sharp XE-A107 - Mode Switch and Display; Mode Switch; Display



■

Insert the mode key (the same key as drawer lock key) into the mode switch and move the key to
get an appropriate mode.
Mode key
: Turns the display off. No operations are
possible.
 Permits transaction entry.
: Permits correction after finalizing a
transaction.
 Permits printing of sales reports and
displaying the flash reports.
 Permits printing and resetting of sales
reports and programming.

■

Your cash register is equipped with a front LED (Light-Emitting Diode) display that affords easy
visibility of 9 digits for the operator during transaction.
Repeat
PLU code
Department code
 Indicates the department entered.
For example, if department 1 was
pressed, “1” would appear.
  Indicates the PLU code entered.
  Indicates the number of times the
same department key or PLU key is
pressed repeatedly. If an entry is
repeated more than ten times, only
the last digit is displayed.

 Appears when an error is made. If this occurs during a transaction because of
an extra digit entry, simply press
l
and re-enter correctly.
 Appears when the cash register is being programmed in the “Z/PGM” mode.
 Appears when a transaction is finalized by pressing
A
,
c
or
C
.
 Appears when the cash register computes a subtotal when
u
is pressed, and
also when an amount tendered is less than the total sales amount.
 Appears whenever a change due amount is displayed.
 Appears when
V
is pressed to calculate a subtotal in foreign currency.
 Appears when the voltage of the installed batteries is under the required level.
You need to replace the batteries with new ones very soon.
 Appears when the batteries are not installed, or the installed batteries are dead.
You must immediately replace the batteries with new ones.
NOTE
 •Whenthedepartmentkeysignissetto“minus”,aminussign(-)appears.
 •Thedecimalpointisshownas“
”.
 •Whensecretcodeisset,“----”appearswhencharactersareentered.

Set the mode switch to the REG position, and press
Q
once to display the time or press Q
twice to display the date.
Press
l
key to cancel the time/date display.