Sharp XE-A107



For the details of EURO programming, please refer to “EURO Migration Function” on pages 21 and 22.
u u
ABCDEFGH
(
u
: to finish programming)
3
  
 Automatic conversion of unit prices of Depts.
/PLUs by automatic EURO migration operation
No* 0
Yes 1
 Conversion rate printing No* 0
Yes 1
 Exchange amount printing for total & change No* 0
Yes 1
 Cheque & credit operation when tendering in
foreign currency
No* 0
Yes 1
 Exchange calculation method Multiplication* 0
Division 1
 Rounding for exchange Rounding up* 0
Rounding 1
 Currency symbol for foreign currency Space* 0
EURO 1
 Decimal point position for foreign currency 0 through 3
(Default: 2)
NOTE
 Ifyouselect“Yes”forexchangeamountprintingfortotalandchange,youcandisplayachange
inforeigncurrencybypressing
V
whenthechangeisdisplayedindomesticcurrency.

When Australian rounding is set, the sales total amount is rounded to 0 or 5 when paid in cash.
u u
0
for No or
1
for Yes
(
u
: to finish programming)
4
(Default: Yes for the register shipped to Australia)

A secret code is used in order to allow only those who know the secret code to operate the machine in
and Z/PGM modes or to print Z reports. When you need a secret code, program a secret code.
Q A
Secret code (max. 4 digits)
(
u
: to finish programming)
(Default: 0000; no application of secret code)

In case that a secret code has been programmed, “----” is displayed when the mode switch is set to
or Z/PGM or when you need to issue a Z report. In this case, enter the secret code (max. 4
digits) and press
A
. Every time you enter a digit, the display of “-” changes to “_”.

Set the mode switch to the Z/PGM position, and operate the secret code programming shown above
with the substitution of “0000” for the secret code.