This cash register displays a low battery symbol ( ) when the batteries installed get low, and
displays a no battery symbol ( ) when batteries are extremely low or batteries are not installed.
, replace the batteries with new ones as soon as
possible. The existent batteries will be dead in about two days.
, replace the batteries immediately. Otherwise, if the AC
power cord is disconnected or a power failure occurs, all the programmed settings will be reset to
the default settings and any data stored in memory will be cleared.
For replacing the batteries, be sure that the cash register is plugged in and the mode switch is on
the REG position, then replace the batteries with new ones referring to “Installing Batteries” section
on page 6.
When printing becomes faded, replace the existing ink roller with a new one available from SHARP.
Ink roller
• Be sure to use an ink roller available from
SHARP. The use of any other ink rollers could
cause troubles in the printer. Never pour ink to
the ink roller.
• After opening the parcel, install it soon.
1. Remove the printer cover.
2. Pull the ink roller handle upward to remove the ink roller.
3. Install a new ink roller.
4. Replace the printer cover.
If power is lost, the machine retains its memory contents and all information on sales entries when
the batteries are in the proper state of charge.
• When power failure occurs in register idle state or during an entry, the machine returns to the
normal state of operation after power recovery.
• When power failure occurs during a printing cycle, the register prints “············” and then carries out
the correct printing procedure.
If the printer motor locks, nothing will operate. First, unplug the AC adapter and repair paper jam.
Then plug in the AC adapter, feed the roll paper to the proper position and press
l
. The register
with then resume correct printing after printing “············”.
To Next Page
Loading...
