In order to check sales, you can read a sales report. Also you should reset sales data after you
practicing your cash register.
To read a sales report, you should take an X report; set the mode switch to the X/Flash position, and
press
A
.
To reset sales, you should take a Z report; set the mode switch to the Z/PGM position, and press
C
. The sales data accumulated and the ground total (GT) is cleared.
If you print a Z report without grand total (GT) resetting, press
A
.
1. Set the mode switch to the X/Flash position.
2. Press
A
.
1. Set the mode switch to the Z/PGM position.
2. Press
C
.
1. Set the mode switch to the Z/PGM position.
2. Press
A
.
For reading and resetting of actual sales data, please refer to “Reading and Resetting of Sales”
section on page 19. You should reset sales data at the end of each day to clear sales data.
To Next Page
Loading...
