Sharp XE-A107 - Page 24


 
(EURO status 1)

(EURO status 2)

(EURO status 3)
General Z report Issue Issue Issue
GT memory - Clear Clear
*2
Conversion of preset prices of Dept./PLU - Yes
*1
Yes
*1
Exchange amount printing for total and
change
Yes Yes No
Exchange calculation method Division Multiplication Multiplication
Domestic currency symbol - [EURO] [EURO]
Domestic currency decimal point position - 2 2
Exchange currency symbol [EURO] Previous domestic
currency symbol
-
*3
Exchange currency decimal point position 2 Previous domestic
currency decimal
point position
-
Rounding of exchange currency Round off Round off Round off
• The item marked with “-” remains the same as the previous data.
*1: If the Automatic conversion of unit prices of Depts./PLUs by automatic EURO migration
operation is set NO (default setting) in EURO Programming, or currency exchange rate is set to
0% (default setting) in Exchange Key Programming, conversion of preset prices of Dept./PLU is
not performed in the Automatic EURO modification operation.
*2: When you perform from EURO status 2, previous data remains unchanged.
*3: When you perform from EURO status 1 or 2, “space” is set.

■

• After the execution of the procedure with “A=1”, treat EURO as foreign currency using
V
. Set the
EURO conversion rate as the currency conversion rate for
V
.
•
After the execution of the procedure with “A=2”, treat EURO as domestic currency and national currency
as foreign currency using
V
. Set the EURO conversion rate as the currency conversion rate for
V
.
• After the execution of the procedure with “A=3”, treat EURO as domestic currency.
• As for the percent rate for
%
and HALO setting, the automatic conversion is not made. So, when
your domestic currency becomes EURO, you must change these settings so that they are based
on EURO currency.
• You can receive the amount of exchange (EURO or national currency) in cheque or credit. For the
programming, please refer to EURO programming on page 26.
• When “Exchange amount printing for total and change” is set to “Yes”, you can display a change
in foreign currency by pressing
V
when the change is displayed in domestic currency.

■

You can check the EURO status currently set on the cash register. Set the
mode switch to the Z/PGM position, (if necessary, enter the secret code and
press
A
) and perform the following procedure. The current EURO status
will be printed on the receipt or journal.
8:uu
EURO status