ENGLISH
20
Adjusting the current channel level
• Each time these buttons are pressed, the
corresponding channel is selected as follows:
< >: Only when the digital signals from Dolby Digital or DTS
program sources are input, these levels can be
displayed.
• Depending on the speaker settings ("N (None or No)") and surround mode, etc., some channels cannot be
selected.
• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
• The LFE level (DD and DTS) is applied after exiting the menu.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory ("CAL"), not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15 ~ +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the
setting as neccessary.
• Then the memory mode ("CAL", etc.) is displayed for
several seconds.
• When the memory mode or channel level
disappears, press this button again.
1. Press the CHANNEL LEVEL button.
2. Select the desired channel.
3. Adjust the level of the selected channel as desired.
4. Repeat the above steps 2 and 3 to adjust each channel level.
To Next Page
Loading...
Need help?
Amplifier Section
