Shibaura CM284 - Page 215

214
Order Unit Disassembling procedure
6 Bearing case
(center)
① Remove the Ø25 snap ring.
② Drive out the shaft
downwards.
1116X
③ Remove the pulley and
bearing together and detach if
necessary.
④ Remove the collar and drive
out the bearing and oil seal.
1117X
Components (bearing case)
1. Bearing case
2. Bearing (6206)
3. Oil seal (UE45629)
4. Shaft
5. Key
6. Collar
7. Bearing (6208Z)
8. Pulley (A)
9. Snap ring (Ø25)
10. Grease nipple
11. Screw pipe
12. Bolt (M6 × 10)
1118X