88
2. TRANSMISSION UNIT
The transaxle assembly must be separated from the
commercial mower to perform service work on the HST,
transmission gearbox, four wheel drive output shaft
differential.
1) Removal
1. Disconnect the negative battery cable.
2. Remove the grip, ①, side cover ②, and fender
③.
3. Disconnect the seat safety switch connectors
under the seat floor and remove the seat assembly,
④, from the seat floor.
4. Pull up the lever and open the floor, and remove
the split pin ①, and separate the damper ②
from the frame.
5. Remove the floor and floor bracket from the
upper frame.
6. Disconnect the parking brake wire ④ from the
both brake levers.
7. Remove the split pin, washer and pin, and
disconnect the brake rod ①, from the both brake
levers.
8. Remove the split pin and pin, and disconnect the
differential lock control rod ② , from the
differential lock lever.
308X
309X
310X
To Next Page
Loading...
