89
9. Disconnect the power steering oil pipes ①, from
the power steering cylinder.
10. Place the safety stands under the main frame.
11. Remove the rear axle bearing holders ②, from
the frame and remove the rear axle assembly ③,
pipe, drive shaft and coupling from the tractor.
12. Remove the fire wall sealed from under the
radiator.
13. Remove the bolt ①, from the universal joint ②,
and disconnect the joint from the HST input shaft
by slide the joint to rearward.
14. Disconnect the wire connector from the HST
neutral switch ①.
311X
312X
313X
To Next Page
Loading...
