218
Reassembly and adjustment
④ Balancing of blade
Fix some suitable bar (below Ø16) to the vice,
install the blade as shown in the right figure and
check that the blade is level. If not, sharpen the
heavier side to balance.
⑤ Installation of blade
Install the blade, leaf spring, and spring washer in
this order and tighten the bolt with the specified
torque.
Tightening torque
132 – 147 N·m
{13.5 – 15 kfg·m}
NOTE: Install the leaf spring with the recess
positioned on the blade side.
1. Blade 3. Spring washer
2. Leaf spring 4. Bolt
1130X
1131X
To Previous Page
