Shini SAL-UGP Series User Manual

54(61)
next setting item. Press to cancel parameter setting and return back to
current setting screen. If you did not change anything, press to enter into
next setting item.
4.5.3 Finish Parameter Setting
Keep on pressing for about 1 sec. to return to normal display mode. If you
did not touch any keys for 20 seconds, the machine will return to normal display
mode without storing any changes of the parameter.
4.5.4 Parameter List of Special Process Setting
Para.
code
Functions Value Note
F.13
Buzzer working mode
Setup buzzer working mode
0: uninterrupted sounding
1: Slow, interrupted sounding
2: Quick, interrupted sounding
0 0-2 -
F.14
Set buzzer sounding period
Set buzzer sounding period: Set [F.13] as 999 to cancel
buzzer sounding function.
999 999 -
F.15
First carbon brush alarm
When carbon brush working hours [F.17] get to a certain
point, [F.14] will raise the alarm. Please replace the
carbon brushes. The alarm will last 5 minutes, and will
repeat every 15 minutes until [F.17] set as 0. Set [F.14] as
0 to cancel this function.
Action code: A.05
80 Unit
10 Hrs
0-999 -
F.16
Second carbon brush alarm
When carbon brush working hours [F.17] get to a certain
point, [F.15] will raise the alarm. Please replace the
carbon brushes. The alarm will last 5 minutes, and will
repeat every 15 minutes until [F.17] set as 0. Set [F.15] as
0 to cancel this function.
Action code: A.06
100 Unit
10 Hrs
[F.14]-999 -
F.17
Third carbon brush alarm
When carbon brush working hours [F.17] get to a certain
point, [F.16] will raise the alarm until [F.17] set as 0.
Please replace the carbon brushes.Set [F.16] as 0 to
cancel this function.
Action code: A.07
110 Unit
10 Hrs
[F.15]-999 -

Shini SAL-UGP Series Specifications

General

Brand	Shini
Model	SAL-UGP Series
Category	Industrial Equipment
Language	English