To Next PageTo Next Page
Need help?Do you have a question about the Shini SHD and is the answer not in the manual?
General| Brand | Shini |
|---|---|
| Model | SHD |
| Category | Industrial Equipment |
| Language | English |
Details how to inspect a damaged heating pipe using a multimeter and its replacement procedure.
Explains how to handle input abnormal alarms E1 and E2 for the dewpoint monitor.
Guides on removing the lid and setting parameters for the dewpoint monitor using its buttons.
Details troubleshooting for specific alarms like E-01, E-02, E-03, E-04, E-05, E-07, E-08, E-10, E-11, E-12.
Provides instructions for routine maintenance tasks like cleaning and checking components.
Outlines the steps for cleaning the honeycomb rotor, including pre-conditioning.
Detailed steps for removing, cleaning, and reassembling the cooler unit.
Covers common causes like high return air temp and incorrect regeneration temp.
Steps for adjusting the K15082-BVKG proximity switch, including wiring details.
Procedure for adjusting the KI0020-BBOA proximity switch, sensitivity, and wiring.
Details how to check for damage by measuring resistance and voltage input.
Step-by-step guide using a multimeter to check microswitch functionality and damage.
Procedure to check the magic eye switch for damage by measuring resistance with a multimeter.
How to check the magnetic reed switch's status (NC) and for damage using a multimeter and magnet.
Step-by-step guide to replace the carbon brush on the 119625-00 brush motor.
Instructions for replacing the carbon brush on the 119656-00 brush motor.
Procedure for replacing the carbon brush on the 122255-00 brush motor.
Methods to correct plastic molding color deviation by adjusting masterbatch and output volume.
Step-by-step instructions for replacing the shaft seal on the TP series turbopump.
