Shini SHD - SCM System Adjustments; SCM Plastic Color Deviation Correction

Shini Group
Technology & Marketing Dept
Issued by department: Date: Language: Document Name: Revision: Page:
Shini/CSC-TM 2013-11 zh-cn Shini product repair manual.doc 1.0 52 (62)
Catalog:
template:Standard_CN.dot; filename: Shini product repair manual; Printdate: 8/1/2014 1:58:00 PM; savedate: 8/1/2014 1:58:00 PM
17. SCM
17.1 Plastic Color Deviation
If out of the plastic molding color deviation can be corrected by the following two
methods:
1) Adjust the proportion of masterbatch F-03. If the plastic color darker, the value of
F-03 can be adjusted to small “properly”; if the plastic color lighter, the value of
F-03 can be adjusted to large “properly”.
2) Adjust the output volume correction F-09. If the plastic color darker, the value of
F-09 can be adjusted to large “properly”; if the plastic color lighter, the value of
F-09 can be adjusted to small “properly”.
Note: The two methods above are empirical methods, it can only be “properly”
adjusted according to the actual situation, and there is no specific adjustment value or
adjustment range.