Shini SHD - Honeycomb-Rotor Blocking; Filter Blocking

Shini Group
Technology & Marketing Dept
Issued by department: Date: Language: Document Name: Revision: Page:
Shini/CSC-TM 2013-11 zh-cn Shini product repair manual.doc 1.0 25 (62)
Catalog:
template:Standard_CN.dot; filename: Shini product repair manual; Printdate: 8/1/2014 1:58:00 PM; savedate: 8/1/2014 1:58:00 PM
9.3.3 Honeycomb-rotor Blocking
Remove the honeycomb, take honey comb toward the light source, check the light
transmission of upper and lower ends. Normally, holes on the honeycomb end
have a good light transmission, light can penetrate two ends. If blocking, please
clean it according to the book 5.4.2.
Pic 9-4
9.3.4 Filter Blocking
Based on actual usage, regular cleaning filters:
Remove the filter;
Use compressed air to clean the lid and filter;
Use a rag to air filter barrel wall;
After cleaning, install filter in reverse order.
Pic 9-5