Shure Incorporated
82/101
4.
•
•
Note: A minimum of 20 minutes of battery charge is required for firmware updates.
Click Update.
Firmware Versioning
When updating firmware, update all hardware to the same firmware version to ensure consistent operation.
The firmware of all devices has the form of MAJOR.MINOR.PATCH (e.g., 1.2.14). At a minimum, all devices on the network,
must have the same MAJOR and MINOR firmware version numbers (e.g., 1.2.x).
Using a Third-Party Control System
The access point and networked charging station connect to external control systems such as AMX or Crestron via the Ether
net. These devices receive logic commands over the network. Many parameters controlled through the web application can be
controlled through a third party control system, using the appropriate command string. Use only one controller per system to
avoid messaging conflicts. For a comprehensive list of command strings, visit pubs.shure.com.
Connection: Ethernet (TCP/IP; select "Client" in the AMX/Crestron program)
Port: 2202
Specifications
System
Latency
Microphone Input to Speaker/Headphone Output 16 ms
Microphone Input to Analog Output 9.2 ms
Analog Input to Speaker/Headphone Output 7.7 ms
Frequency Response
Headphone Output 100 Hz -20 kHz (+0.5 dB/-3 dB)
Speaker Output 220 Hz Hz -15 kHz (±10 dB)
Total Harmonic Distortion
Headphone Output 0.06%, typical
Speaker Output 1%, typical
Dynamic Range
Headphone Output 100 dB (A-weighted), 97 dB (Unweighted), typical
Speaker Output (unweighted), typical 94 dB (A-weighted), 91 dB (Unweighted), typical
Digital Signal Processing
24-bit , 48 kHz
To Next Page
Loading...
