Shure MXA710 - Step 3: Adjust Microphone Coverage

Shure Incorporated
6/43
2.
◦
◦
◦
◦
3.
4.
1.
2.
3.
Check the audio routes and settings to make sure they fit your needs. You might need to:
Delete unnecessary routes.
Verify that AEC reference signals are correctly routed.
Fine-tune DSP blocks as needed.
Check matrix mixer routes.
You can also route audio manually in Designer or use Dante Controller to route to third-party devices.
Send audio from the ANIUSB-MATRIX to other sources using the matrix mixer. A common destination is a computer
connected by USB with videoconferencing software.
Select Deploy and connect to send device settings to your installed online devices. Designer walks you through associ
ating the design devices with the online devices.
Step 3: Adjust Microphone Coverage
Go to [Your room] > Coverage to adjust the MXA710's coverage.
Set up a way to listen to the microphone directly (with a Dante headphone amp, for example). Listen to each of your
microphone's channels and adjust the lobe position, width, and gain as needed. The solid line in each lobe shows
where pickup is the strongest. The lobe's edge is −6 dB down from the solid line.
Place a test call with the whole conferencing system. Adjust gain and DSP as needed to get a good room sound.