2 Safety information
2.1 Intended use
The device is an intelligent, opto-electronic SICK ID sensor and is used for automatic,
fixed identification and decoding of bar codes on moving or stationary objects. The data
content of the decoded bar codes is sent by the device to a higher-level control (PLC) for
further coordinating processing.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.2
Incorrect use
•
The device does not constitute a safety-relevant device according to the EU Machi‐
nery Directive (2006/42/EC).
•
The device must not be used in explosion-hazardous areas.
•
The device must not be used in forklift applications in low temperature conditions.
•
Any other use that is not described as intended use is prohibited.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Device should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
2.3 IP technology
NOTE
SICK uses standard IP technology in its products. The emphasis is placed on availability
of products and services. SICK always assumes that the integrity and confidentiality of
the data and rights affected by the use of the aforementioned products will be ensured
by the customer. In all cases, appropriate security measures, such as network separa‐
tion, firewalls, virus protection, and patch management, must be taken by the customer
on the basis of the situation in question.
2.4 Limitation of liability
Applicable standards and regulations, the latest state of technological development,
and our many years of knowledge and experience have all been taken into account
when assembling the data and information contained in these operating instructions.
The manufacturer accepts no liability for damage caused by:
■
Failing to observe the operating instructions
■
Incorrect use
■
Use by untrained personnel
■
Unauthorized conversions
■
Technical modifications
■
Use of unauthorized spare parts, consumables, and accessories
SAFETY INFORMATION 2
8019588/2017-01-20 | SICK O P E R A T I N G I N S T R U C T I O N S | CLV63x, CLV64x, CLV65x
7
Subject to change without notice
To Next Page
Loading...
Need help?
General
