Activities Qualification
Operation of the device for
the particular application
■
Knowledge of device control and operation in the particular
application concerned (e.g. conveying line)
■
Knowledge of the software and hardware environment for
the particular application concerned (e.g. conveying line)
Table 1: Activities and technical requirements
2.7 Hazard warnings and operational safety
Please observe the safety notes and the warnings listed here and in other chapters of
these operating instructions to reduce the possibility of risks to health and avoid dan‐
gerous situations.
2.7.1 Laser radiation
The device works with a red light laser diode in the wavelength range between 650 nm
and 660 nm.
CAUTION
Optical radiation: Laser class 2
The human eye is not at risk when briefly exposed to the radiation for up to 0.25 sec‐
onds. Exposure to the laser beam for longer periods of time may cause damage to the
retina. The laser radiation is harmless to human skin.
■
Do not look into the laser beam intentionally.
■
Never point the laser beam at people's eyes.
■
If it is not possible to avoid looking directly into the laser beam, e.g., during com‐
missioning and maintenance work, suitable eye protection must be worn.
■
Avoid laser beam reflections caused by reflective surfaces. Be particularly careful
during mounting and alignment work.
■
Do not open the housing. Opening the housing will not switch off the laser. Open‐
ing the housing may increase the level of risk.
■
Current national regulations regarding laser protection must be observed.
Laser class
Figure 1: Laser output aperture of the different designs
SAFETY INFORMATION 2
8019588/2017-01-20 | SICK O P E R A T I N G I N S T R U C T I O N S | CLV63x, CLV64x, CLV65x
9
Subject to change without notice
To Next Page
Loading...
Need help?
General
