SICK IDM161 - HID Mode Operation

Radio Link Mode
Operating Instructions
IDM corded
& IDM Bluetooth
18
© SICK AG · Germany · All rights reserved · Subject to change without notice
8017159/142O/2019-05-23
For using the Clone function, the paired scanners need to stay connected. The host interface related
parameters can’t be cloned to the paired scanner in disconnected status.
Save Configuration
Clone
The below host interface related parameters will be impacted by the cloning function:
Data Transmission Parameter
Field Delimiter
Data Transmission Format
Host Interface Control
Host interface Selection
Keyboard Interface Control
Keyboard Layout
Intermessage Delay
Interfunction Delay
Intercharacter Delay
Caps Lock Control
Caps Lock Release Control
Function Key Emulation
Key Pad Emulation
Upper/Lower Case
Serial Interface Control
Handshaking Protocol
Intermessage Delay
Interfunction Delay
Intercharacter Delay
Baud Rate
Data Frame
Time Out Control
Wand Emulation Control
Output Polarity
Initial Signal State
Margin Time
Module Time
Narrow/Wide Ratio
Code39 Emulation
2.3.3 HID Mode
Through the HID service, the scanner can work as a Bluetooth Keyboard. In this mode, the scanner will be
discoverable by the radio connection request issued by the remote host device. In some cases, you may be
requested to enter the Passkey (PIN) to establish the Bluetooth connection for security purpose.