SICK IDM161 - Center Alignment, Unique Barcode Reporting

Operation Control
Operating Instructions
IDM corded
& IDM Bluetooth
90
© SICK AG · Germany · All rights reserved · Subject to change without notice
8017159/142O/2019-05-23
3.9.10 Center Alignment, Unique Barcode Reporting
PROGRAM
F_DEFAULT
Option Code
Family Code
Selection
P.C. Parameter Selection
1D Corded
(IDM1x0)
2D Corded
(IDM2x0)
1D BT
(IDM1x1)
2D BT
(IDM2x1)
Center Alignment
SS Disable in Hand-Held mode  - 0 - 0
SS Enable in Hand-Held mode - 1 - 1
SS Disable in Hands-Free mode  - 2 - 2
SS Enable in Hands-Free mode - 3 - 3
Unique Barcode
Reporting
SS Disable  - 0 - 0
SS Enable - 1 - 1
Center Alignment
When this function is enabled, the scanner only decodes barcode(s) around the aiming line.
Unique Bar Code Reporting
When this function is enabled, the scanner will only output data from each barcode once during a scanning
cycle (trigger key pressed and
held without release). This prevents the output of repeat data in case a barcode
is accidentally read multiple times during the same scanning cycle. For Multiple Read mode only.
Hand-Held mode: Low power mode, Trigger mode, Alternative mode, Toggle mode, Level mode, Multiple read
mode
Hands-Free mode: Presentation mode, Force mode, Diagnostic mode