SICK Inspector PIM60 User Manual

Table B.4 Command channel - actions
RangeReturn
values
Argu-
ments
Usable in
Run mode
Identi-
fier
Com-
mand
Description
-No1aACTSave settings in
flash
0=use expos-
ure settings,
1=auto adjust
int auto-
Exp
Yes, only in
Run mode.
2aACTRe-teach reference
object
>0
[0,100]
-
int calib-
rationCov-
erage
c
int box-
Size
b
No3aACTPerform calibration
a
No4aACTRemove calibration
0=use manual
settings,
1=use DHCP
int useDH-
CP
Yes5aACTApply IP settings
d
Both in run
and edit
mode
6aACTRestart the Inspect-
or
e
No7aACTPerform (calculate)
coordinate align-
ment
f
a
In order to run this command the device must be set to Calibration mode (sINT 20 1).
b
The argument must be given in mm.
c
Returned value is the calibration target coverage in percent.
d
After the aACT 5 command has been executed the Inspector need to be restarted (e.g. using aACT 6) before the
new IP settings are in use.
e
The aACT 6 command will make the device being temporarily disconnected while it is rebooted.
f
This command can only be used if the 4 control points have been set via the sINT 300 command
55
©SICK AG • Advanced Industrial Sensors • www.sick.com • All rights reserved
Subject to change without notice
8015726/2013-11
Appendix
Command channel
Reference Manual
Inspector PIM

SICK Inspector PIM60 Specifications

General

Brand	SICK
Model	Inspector PIM60
Category	Accessories
Language	English