Table B.22 Error codes - Configuration errors
DescriptionError code
No error0
Operation is not allowed in current mode8100
The reference bank is not used on the device8101
Operation is not allowed, for example trying sINT 20 0 when not in calibration
mode
8102
Calibration mode is not enabled when trying to perform calibration or trying to
remove non-existent calibration
8103
No object locator is available in current reference bank8104
No blob tool with this index exists8105
Polygon defect detection is not enabled8106
No polygon with supplied index exists8107
No pixel counter with supplied index exists8108
No edge pixel counter with supplied index exists8109
No pattern inspection with supplied index exists8110
The move or rotation caused the ROI to appear outside of the FOV8111
Trig is not activated8112
The specified IP address was invalid, or an invalid combination of addresses
was used
8113
The specified network mask was invalid8113
The specified gateway address was invalid8113
The combination of IP settings was invalid8113
Calibration failed8114
Interface not available. Only interfaces that exist in the product can be en-
abled/disabled
8115
No edge tool with supplied index exists8116
No angle tool with supplied index exists8117
No circle with supplied index exists8118
No distance tool with supplied index exists8119
The specified tool does not have a region (it is a measurement)8120
The tool type of the specified tool does not support this command8121
No tool with supplied index exists8122
No edge count tool with supplied index exists8123
Search region is not enabled8124
Width or height is invalid8125
No tools in configuration8126
Invalid unit specified8127
Alignment to specified control points failed8128
8015726/2013-11
©SICK AG • Advanced Industrial Sensors • www.sick.com • All rights reserved
Subject to change without notice
74
Reference Manual
Command channel
Appendix
Inspector PIM
To Next Page
Loading...
Need help?
General
