SICK MPS-G 1108675 - Connections; Pin Assignment;Connection Diagram + Wire Colors; Connecting the Supply Voltage

6.2 Connections
6.2.1 Pin assignment/Connection diagram + wire colors
MPS-GxxxxxxxAxxxxxxxxxxxxxxxxx: Open cable end
Table 6: Pin assignment for male connector, M8, A-coded, 4-pin
PIN Connection Pin assignment
1 BN + (L+)
2 WH Q2
3 BU - (M)
4 BK Q1
0.08 mm
2
A
W
G 26
MPS-GxxxxxxxCxxxxxxxxxxxxxxxxx / MPS-GxxxxxxxDxxxxxxxxxxxxxxxxx: M8 connection
Table 7: Pin assignment for male connector, M8, A-coded, 4-pin
PIN Connection Pin assignment
1 BN + (L+)
2 WH Q2
3 BU - (M)
4 BK Q1 / IO-Link
2
1
4
3
MPS-GxxxxxxxExxxxxxxxxxxxxxxxx: M12 connection
Table 8
: Pin assignment for male connector, M12, A-coded, 4-pin
PIN Connection Pin assignment
1 BN + (L+)
2 WH Q2
3 BU - (M)
4 BK Q1 / IO-Link
12
3 4
6.3 Connecting the supply voltage
The sensor must be connected to a voltage supply with the following properties:
•
Suppl
y v
oltage DC 10 V ... 30 V (SELV/PELV as per currently valid standards)
•
Electricity source with at least 5 W power
6 ELECTRICAL INSTALLATION
22
O P E R A T I N G I N S T R U C T I O N S | MPS-G with 2 / 3 switching points and IO-Link (up to 16 switching points) 8025942/2020-07-16 | SICK
Subject to change without notice