The sensor detects the movement stops and then assigns the respective switching points to the found positions.
(T
aking into account the set switching point width, the positions must be at least 1 mm apart to be detected as two
different positions).
The initial position of the piston when Dynamic Teach starts is NOT seen as the first stop!
NOTE
The magnet must be moved at a speed greater than 0.025 m/s so the Dynamic Teach works correctly.
OPERATION 8
8025942/2020-07-16 | SICK O P E R A T I N G I N S T R U C T I O N S | MPS-G with 2 / 3 switching points and IO-Link (up to 16 switching points)
29
Subject to change without notice
To Next Page
Loading...
