SICK MRS1000 User Manual

2 Safety information
2.1 Intended use
The MRS1000 3D LiDAR sensor features 4 scan planes and is designed for the
following applications:
•
Detection of objects during continuous output of measured data as required
•
Field monitoring of freely defined areas with signaling of field breaches via switch‐
ing outputs
It is suitable for applications which demand precise, non-contact optical measuring
contours and dimensioning.
Typical areas of application include property/building protection, access monitoring,
and collision protection.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.2 Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Product should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
■
Shut down the product immediately in case of damage.
2.3 Internet protocol (IP) technology
NOTE
SICK uses standard IP technology in its products. The emphasis is placed on availability
of products and services.
SICK always assumes the following prerequisites:
•
The customer ensures the integrity and confidentiality of the data and rights
affected by its own use of the aforementioned products.
•
In all cases, the customer implements the appropriate security measures, such as
network separation, firewalls, virus protection, and patch management.
SAFETY INFORMATION 2
8020494/1AZF/2021-05-10 | SICK O P E R A T I N G I N S T R U C T I O N S | MRS1000
7
Subject to change without notice

SICK MRS1000 Specifications

General

Brand	SICK
Model	MRS1000
Category	Accessories
Language	English