7
For CDB650-204: Connection cable 1:1 (female connector, M12, 17-pin, A-coded/male
connector, M12, 17-pin, A-coded)
For CDM420-0006: Adapter cable (female connector, M12, 17-pin, A-coded / male con‐
nector, D-Sub-HD, 15-pin)
8
Cable (male connector, TNC reverse/male connector, TNC reverse)
Procedure:
1. Connect the communication interface (e.g., Ethernet) of the device directly to the
PC using the suitable cable 6.
2. Connect external antennas (maximum 4, e.g. RFA630-000) to the antenna inputs
of the device by means of suitable connecting cables 8. At least one external
antenna is required!
3. Connect "Power/Serial Data/CAN/I/0" connection (male connector, M12, 17-pin,
A-coded) to the corresponding female connector on the connection module using
the suitable cable 7.
4. If necessary, connect a read cycle trigger sensor, such as a photoelectric retro-
reflective sensor, to the “Sens/IN 1” (CDB650-204) or “Sensor 1”
(CDM420-0006) digital switching input of the connection module. For
CDB650-204: see "Wiring digital switching inputs “Sensor 1” and “Sensor 2” of
the device in the CDB650-204", page 109. For CDM420-0006 see "Wiring digital
switching inputs “Sensor 1” and “Sensor 2” of the device in the CDM420-0006",
page 122.
5. Supply the device with required voltage depending on the length of the connecting
cable 7. see "Supply voltage", page 63.
✓
After successful initialization, the “Device Ready” LED lights up green.
6. Turn on the PC and start Windows.
RFU65x-101xx
Cable 6 Cable 5
SOPASSOPAS
"Power/Serial Data/CAN/I/O"
(Aux 1, Host 1)
...
...
1
2
V
S
GND
PC
"Ethernet" (Aux 2)
Ready
Result
RF
Data
CAN
LNK TX
microSD
TeachIn
Antenna
Sync
Userdef.
Read Diagn
RFU65x-101xx
2
11 10 12
Trigger
sensor
SGND
Sens 1
V
S
1
Out
GND
V
S
3
Connection
module
4
EthernetEthernet
Configuration
Reading result
display
Transponder
access
Reading
diagnostics
Figure 32: Commissioning: Electrical connection block diagram of the RFU65x-101xx with
optional connection module
1
Reading pulse trigger
2
Supply voltage V
S
3
CDB650-204 or CDM420-0006 connection module
4
Configuration, diagnosis, transponder access or display of read results
5
Adapter cable (male connector, M12, 4-pin, D-coded / male connector, RJ-45, 8-pin)
6
For CDB650-204: Connection cable 1:1 (female connector, M12, 17-pin, A-coded / male
connector, M12, 17-pin, A-coded)
For CDM420-0006: Adapter cable (female connector, M12, 17-pin, A-coded / male con‐
nector, D-Sub-HD, 15-pin)
ELECTRICAL INSTALLATION 6
8014335/ZTL9/2018-10-14 | SICK O P E R A T I N G I N S T R U C T I O N S | RFU63x, RFU65x
57
Subject to change without notice
To Next Page
Loading...
