1
Trigger sensor for read cycle
2
Supply voltage V
S
(V
S
= U
V
)
3
Connection module CDB650-204 or CDM420-0006
4
Configuration with SOPAS ET, prepared representation of the read result, transponder
access or reading diagnostics
5
Adapter cable (male connector, M12, 4-pin, D-coded/male connector, RJ-45, 8-pin)
6
For CDB650-204: Connection cable 1:1 (female connector, M12, 17-pin, A-coded/male
connector, M12, 17-pin, A-coded)
For CDM420-0006: Adapter cable (female connector, M12, 17-pin, A-coded / male con‐
nector, D-Sub-HD, 15-pin)
Procedure:
1. Connect the communication interface (e.g., Ethernet) of the device directly to the
PC using the suitable cable 5.
2. Connect "Power/Serial Data/CAN/I/0" connection (male connector, M12, 17-pin,
A-coded) to the corresponding female connector on the connection module using
the suitable cable 6.
3. If necessary, connect a read cycle trigger sensor, such as a photoelectric retro-
reflective sensor, to the “Sens/IN 1” (CDB650-204) or “Sensor 1”
(CDM420-0006) digital switching input of the connection module. For
CDB650-204: see "Wiring digital switching inputs “Sensor 1” and “Sensor 2” of
the device in the CDB650-204", page 109. For CDM420-0006 see "Wiring digital
switching inputs “Sensor 1” and “Sensor 2” of the device in the CDM420-0006",
page 122.
4. Supply the device with the required voltage depending on the length of the con‐
necting cable 7. see "Supply voltage", page 63.
✓
After successful initialization, the “Device Ready” LED lights up green.
5. Turn on the PC and start Windows.
6.6.2 Block diagram: wiring the optional connection module
Device = RFU63x, RFU65x
NOTE
For possible combinations of the device and various connection modules, see table 12,
page 59
6 ELECTRICAL INSTALLATION
58
O P E R A T I N G I N S T R U C T I O N S | RFU63x, RFU65x 8014335/ZTL9/2018-10-14 | SICK
Subject to change without notice
To Next Page
Loading...
