Siemens 6ES7153-1AA03-0XB0 - Page 178

Functions
8.7 Identification and maintenance data (I&M data)
ET 200M
178 Operating Instructions, 04/2022, EWA-4NEB7806006-09
Table 8- 13 Structure of I&M data
I&M data
Access
Default
Description
Identification data 0: (data record index AFF0 hex)
VendorIDHigh
read (1 bytes)
00 hex
This is where the name of the manufacturer
is saved. (42 dec = SIEMENS AG)
VendorIDLow
read (1 bytes)
2A hex
Order_ID
read (20 bytes)
Order number of the module
IM_SERIAL_NUMBER
read (16 bytes)
-
Serial number (device specific)
IM_HARDWARE_REVISION
read (2 bytes)
1
Corresponding hardware version
IM_SOFTWARE_REVISION
read
Firmware version
Indicates the firmware version of the mod-
ule.
•
SWRevisionPrefix
(1 byte)
V, R, P, U, T
• IM_SWRevision_Functional_
Enhancement
(1 byte)
00 - FF hex
•
IM_SWRevision_Bug_Fix
(1 byte)
00 - FF hex
• IM_SWRevision_Internal_
Change
(1 byte)
00 - FF hex
IM_REVISION_COUNTER
read (2 bytes)
-
Provides information on parameter modifi-
cations on the module.
IM_PROFILE_ID
read (2 bytes)
0000
Generic device
IM_PROFILE_SPECIFIC_TYPE
read (2 bytes)
0005 hex
on interface modules
IM_VERSION
read
0101 hex
Provides information about the version of
the identification data.
(0101 hex = Version 1.1)
• IM_Version_Major
(1 byte)
•
IM_Version_Minor
(1 byte)
IM_SUPPORTED
read (2 bytes)
000E hex
Provides information about the available
identification data. (I&M1 to I&M3)
Maintenance data 1: (data record index AFF1 hex)
IM_TAG_FUNCTION
Read / write
(32 bytes)
-
Define a unique identifier for the module in
this record.
IM_TAG_LOCATION
Read / write
(22 bytes)
-
Define the installation location of the mod-
ule.
Maintenance data 2: (data record index AFF2 hex)
IM_DATE
Read / write
(16 bytes)
YYYY-MM-DD HH:MM
Enter the installation date of the module
here.
Maintenance data 3: (data record index AFF3 hex)
IM_DESCRIPTOR
Read / write
(54 bytes)
-
Define a comment describing the module in
this record.
Further explanations about identification and maintenance data can be found in the "From
PROFIBUS DP to PROFINET IO
(http://support.automation.siemens.com/WW/view/en/19289930)" programming manual
under chapter "Identification and maintenance".