Siemens 6ES7153-1AA03-0XB0 - Compatibilities between the IM 153-X; Compatibilities between the Versions of IM 153 and IM 153-1

ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
241
Compatibilities between the IM 153-x
A
This chapter includes the most important information that you must know if you are
"changing over" from an old IM 153-x to a new or different IM 153-x.
A.1 Compatibilities between the versions of IM 153 and IM 153-1
The versions of IM 153-1
Table A- 1 Properties and variants of the IM 153-1
Functions / properties Interface module with order number
6ES7153-1AA..
00
01
02
03
82
83
Min_slave_interval between two slave list cycles
1 ms
0,1 ms
0,1 ms
0,1 ms
0,1 ms
0,1 ms
SYNC, FREEZE
–
x
x
x
x
x
Module change during operation
–
–
x
x
–
–
Direct data exchange
–
–
as of E07
x
as of E06
x
Enhanced diagnostics
•
64 byte diagnostic frame
–
–
–
x
as of E02
–
x
Extended range of environmental conditions (out-
doors)
–
–
–
–
x
x
RC network with 10 MΩ for unearthed configuration
-
(1 MΩ)
-
(1 MΩ)
as of E08
x
as of E07
x
DPV1-mode
–
–
–
as of E05
–
as of E03
E = module version
Compatibility between 153-1AA00- and 153-1AA01-…
The IM 153-1, order number 6ES7153-1AA01-0XB0 is partially upwards compatible. This
means that the configuration and the user programs for the IM 153-1, order number
6ES7153-1AA01-0XB0 can also be used for the IM 153, order number 6ES7153-1AA00-0XB0,
apart from if you are working with SYNC and FREEZE in these user programs. Note also the
different min_slave-intervals (refer to table above).
Retrofitting to 153 1AA02 ...
The IM 153-1 with order number 6ES7153-1AA01-0XB0 can be retrofitted to the IM 153-1
with order number 6ES7153-1AA02-0XB0.
Contact your Siemens representative for this.